Seeking opinions on setting up a bench/stand/support for the Smithy. What is the best height for the support structure under one of these 3n1's? I am average height at 5'9" (or 175cm.)
What does your bench/table/stand measure? Is there a general rule where the chuck should be in relation to ones waist or elbow for good ergonomics? Since the head is able to rotate, I am not too concerned about it being too low; but so many people have commented on hitting their head, I may be missing...
Building a stand for the Smithy
What does your bench/table/stand measure? Is there a general rule where the chuck should be in relation to ones waist or elbow for good ergonomics? Since the head is able to rotate, I am not too concerned about it being too low; but so many people have commented on hitting their head, I may be missing...
Building a stand for the Smithy