I have a Central Machine 3 in 1. The tool block holds the carbide tools slightly above lathe center. It is one of the 4 way rotating blocks that came with the (used) machine. Is it possible to disassemble the tool holder, remove a little bit of the base, and if so, should the cutters be centered or a little below center? Or is this normal and I need to deal with it another way?
Btw, I am strictly an amateur. This may or may not make sense. But someone must have had the same problem....
Tool block above center
Btw, I am strictly an amateur. This may or may not make sense. But someone must have had the same problem....
Tool block above center